Is T1-11 Siding Bad? Can You Repair It, Go Over It, or Do You Have to Replace It?

Thomas Williams, All American Renovations – Elite member of James Hardie™ ALLIANCE · Metro Atlanta and Middle Georgia

If you’ve got T1-11 siding that’s faded, flaking, and going soft along the bottom, you’re probably asking the same two questions everybody asks me: can we just go over it, or can we match it and fix the bad spots? Here’s the straight answer on T111 siding, and it isn’t the one you’d expect from somebody who sells replacement siding. Yes, it can be repaired. The real question is how long you plan to stay in the house and how many more times you want to deal with it.

What Is T1-11 Siding, And Why Does It Rot At The Bottom?

T1-11 is plywood siding. It comes in 4×8 sheets with grooves cut down the face every few inches, so a whole wall goes up fast and looks like vertical boards. You’ll also see it written T111 or T1-11. Same product.

When I pull up to a house with T1-11, it usually looks the same: old, faded siding, with worn or rotted spots near the bottom. That’s the part of the wall that takes the most water, from rain splash, from the ground, and from gutters that overflow.

Here’s why it got that far, and it’s not a knock on anybody. Wood siding needs paint on a schedule, and most people don’t paint it as often as they should. Remembering to paint your siding every year or every other year just isn’t on anybody’s radar. We’re all busy. Once the paint goes, water gets into the plywood, and plywood that stays wet comes apart.

How Can You Tell If Your T1-11 Has Gone Too Far?

You don’t need a ladder or a tool for this. Walk your house and look at the bottom couple of feet of every wall.

Look for three things:

  • The plywood peeling apart in layers. We call it delamination. The sheet starts coming apart like a stack of paper that got wet, usually at the bottom edge first.
  • Paint that’s flaking off, not just dull. Bare wood showing through means water is getting in.
  • Paint that’s faded hard, especially on the sunny sides of the house. That’s the early warning before the flaking starts.

If you see layers coming apart, that section is done. Paint won’t hold it together.

On the job, once the siding is off, we use a hammer test on the framing. A normal hit, not digging in with the claw. If the wood takes the hit, it’s sound. If it flies to pieces or just falls apart, it needs repair or replacement. You can tap your own siding the same way if you want to, but you don’t have to. If it looks like what I described above, you already have your answer, and a professional can tell you the rest without swinging anything.

Can You Just Repair The Bad Sections Of T1-11?

Yes. I’ll say that plainly, because a lot of replacement contractors won’t.

But here’s how I’d do it, and how I wouldn’t. Some people cut out just the bottom strip of the bad sheets and patch in a new piece. I won’t do it that way. It looks like a patch, and to me it shows too much.

If I’m doing a repair, it’s a whole 4×8 sheet. And because the damage is almost always along the bottom, that usually means several sheets, not one.

Can you match what’s there? That depends on the exact design on your house and what’s still made today. Sometimes it’s close. Sometimes it isn’t, and you’ll be painting the whole wall anyway to tie it together.

So the repair question really comes down to two things:

  1. How long are you going to be in this house? If you’re selling in a year or two, a sheet repair and a good paint job can be the right call.
  2. How many more times do you want to deal with this? If you’re staying, the sheets you didn’t replace are the same age as the ones that failed.

Once you’re replacing several sheets on every side, it’s worth pricing out a full replacement before you spend money patching.

Can You Install New Siding Over T1-11?

No. This is the one I hold the line on.

T1-11 has those grooves every few inches. When a groove lands on a stud and you nail new siding through it, the nail punches through the thin wood at the bottom of the groove, and the head goes right through the board. The holding power of a siding nail is in the head. A head that punches through holds nothing. The nail is in the stud and the siding is just hanging there.

That goes for every kind of old siding, not just T111 siding. I covered the whole question in can you install new siding over old siding.

I’ll be honest: we learned this one the hard way. Early on we treated T1-11 like a solid wall you could nail through, and we learned otherwise. My dad used to say, “Experience is the best education, it just costs so much.” That’s exactly what this one cost us.

There’s a second reason. Installing James Hardie over existing siding goes against James Hardie’s installation requirements, and it voids the 30-year non-prorated product warranty. If it fails, they point at the installer. We won’t do it, and we couldn’t warranty it if we did.

Tearing off old wood or LP siding on a typical house runs about $2,500 to $3,000 as of late 2026 in Middle Georgia and Metro Atlanta. It should never be $8,000 to $15,000. That’s what going over it would save you, and it’s not worth what you’d be giving up.

What’s Behind T1-11 When You Take It Off?

Usually nothing. Just studs and insulation.

That surprises people, and it’s the most important thing in this post. On a lot of houses, T1-11 was the siding and the wall sheathing in one sheet. Take it off and you can see the insulation from the yard.

Sheathing isn’t a code requirement. But it’s our recommendation to install OSB and then housewrap before any new siding goes on. You get a solid wall to nail to, and a real water barrier behind the siding, which the house never had.

It’s also the perfect time to update the insulation if it needs it. The wall is already open. You’ll never get easier access.

On our proposals, the OSB is an upgrade option you can check on or off, the same as any other line on a siding proposal. You decide. We’ll just tell you why we recommend it.

What Do You Replace T1-11 Siding With?

Most people who want to keep the vertical look go with smooth Hardie® Panel with smooth batten strips for a board and batten look. If you liked the texture of the old T1-11, there’s also Hardie® Panel in Sierra 8 or Cedarmill with rough-sawn battens. Sierra 8 was discontinued for a while but now it’s back. We’ve only used it on a job or two, because the smooth board and batten look is far more popular.

But here’s what I see more and more: most customers don’t do the whole house in board and batten anymore. They use it as an accent, on a gable or the front, and go with lap siding everywhere else.

The last T1-11 house I can remember tearing off, the homeowner went all lap siding. It completely changes the look. It takes the house from an ’80s or ’90s style to something closer to what most people picture today. It comes down to what you want to see when you pull in the driveway.

Want a number before you call anybody? Our siding cost calculator gives you an installed price range for your house in a few minutes.

What I’d Tell You If You Called Me

  • Walk the bottom two feet of every wall. Layers coming apart means that section is done.
  • If you’re selling soon, repair it with whole sheets and paint. Don’t let anybody cut in a strip.
  • If you’re staying, price the replacement before you pay for the repair. Several sheets per side is the tipping point.
  • Don’t let anybody install over it. Ask every contractor: “Are you tearing the T1-11 off, or going over it?”
  • Plan on sheathing. There’s probably nothing behind your T1-11 but studs.

If you want a straight answer on your house, give us a call. We’ll tell you whether a repair gets you where you’re going, or whether it’s time. Learn more about our siding replacement work.

Need a straight answer?

If you want a straight answer on your house, give us a call. We’ll tell you whether a repair gets you where you’re going, or whether it’s time. Learn more about our siding replacement work.

For homes in Metro Atlanta, our Atlanta siding replacement page shows what siding jobs there actually cost.

Scroll to Top